Menu
Cart 0
SCIGRIP IPS Weld-On #3061 - Thinner for #40 - Pint

Must Be Shipped Ground

SCIGRIP IPS Weld-On #3061 - Thinner for #40 - Pint

  • $30.62


Description

IPS's Weld-On #3061 Clear Reactive Diluent (Thinner) for Weld-On #40 1 Pint

Technical
Download - Technical Data Sheet

Color Clear VOC Content <50 g/l mixed
Viscosity Water Thin Specific Gravity 0.944 ± 0.01
Directions
  • DO NOT dilute by more than 10% by weight or volume. Excessive dilution may adversely affect cure times or adhesive properties of SCIGRIP 40
  • Add SCIGRIP 3061 to mixed SCIGRIP 40 and stir gently avoiding the introduction of air.
  • Let mixture stand for a minute or two allowing air to escape mixture.
  • Safety
    Download - Safety Data Sheet

    SAFETY AND ENVIRONMENTAL PRECAUTIONS

    This product is a flammable, fast evaporating solvent. It is considered a hazardous material. In conformance with the Federal Hazardous Substance Labeling Act, the following hazards and precautions are given. Purchasers who may re-package this product must also conform to all local, state, and federal labeling, safety and other regulations.

    WARNING! EXTREMELY FLAMMABLE. VAPOR HARMFUL. MAY BE HARMFUL IF SWALLOWED. MAY IRRITATE SKIN OR EYES.

    Keep out of reach of children. Do not take internally. Keep away from heat, spark, open flame and other sources of ignition. Keep container closed when not in use. Store away from direct sunlight between 40°F – 110°F (5°C – 43°C). Use only in adequate ventilation. Avoid breathing of vapors. Atmospheric levels should be maintained below established exposure limit values contained in Section II and VIII of the Material Safety Data Sheet. If airborne concentrations exceed these limits, use a chemical cartridge respirator or a supplied air respirator. For emergencies and other conditions where short-term exposure may be exceeded use an approved positive pressure self-contained breathing apparatus. In confined areas, use aforced ventilation or NIOSH approved respirator. Do not smoke, eat or drink while working with product. Avoid contact with skin, eyes and clothing. May cause eye injury. Protective equipment such as gloves, safety goggles and impervious apron may be used. Carefully read Material Safety Data Sheet and follow all precautions. Contains Methyl Methacrylate Monomer (80-62-6). Extent of health risk depends on level and duration of exposure, as well as individual sensitivity. Do not use this product for other than intended use. “Title III Section 313 Supplier Notification:” This product contains toxic chemicals subject to the reporting requirements of Section 313 of the Emergency Planning and Community Right-to-Know Act of 1986 and of 40CFR372. This information must be included in all Material Safety Data Sheets that are copied and distributed for this material.

    FIRST AID

    Inhalation: If overcome with vapors, remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Call physician.

    Eye Contact: Flush with plenty of water for 15 minutes. If irritation persists, get medical attention.

    Skin Contact: Wash skin with plenty of soap and water for at least 15 minutes. If irritation develops, get medical attention.

    Ingestion: If swallowed, do not induce vomiting. Contact physician immediately.

    SHIPPING

    Shipping Information for One Liter and Above: Proper Shipping Name: Methyl Methacrylate Monomer, Stabilized DOT Hazard Class: 3. ID #: UN 1247. Packaging Group: PG II. Label: Class 3 Flammable Liquid.

    For Less than One Liter: DOT Shipping Name: Consumer Commodity. DOT Shipping Class: ORM-D.


    We Also Recommend